set bitrate : sets the serial bitrate to a new value.set speed : sets the CPU clock frequency (default: 160).set addr : sets the IP address of the SLIP interface (default: 192.168.240.1).set ssid|pasword : changes the named config parameter.show : prints the current config and status.The console understands the following command:
from the host attached to the serial line - see above). This console is available via tcp port 7777 (e.g. The default config of the router can be overwritten and persistenly saved to flash by using a console interface. rapidly blinking: in- or outgoing traffic.permanently off: connected (or SoftAP active), no traffic.permanently on: not connected (initial state after boot).The status LED (default: GPIO2) indicates: Echo 'nameserver 9.9.9.9' > /etc/nfĪ script may help to automize this process.
